Suzuki DL1000AL4 Instrucciones Para El Montaje página 9

Installation of lead wires
1. Pass the grip heater lead wire
between the switch box and the
front brake master cylinder
holder. Align the white tape part
of the grip heater lead wire with
the contact surface of the front
brake master cylinder holder,
and fix them by using a Clamp
F.
CAUTION
Fix the grip heater lead wire
securely by using a clamp so
that no tension should be felt
in the throttle grip lead wire
when operating the throttle.
NOTE: Cut off the excess clamp.
2. Cut off the vehicle clamp and fix
the grip heater lead wire as
before by using Clamp F.
NOTE: Cut off the excess clamp.
3. Pass the grip heater lead wire
into the cable guide along the
handle switch lead wire.
Grip heater Grip heater
lead wire lead wire
Cable guide Cable guide
GENUINE SUZUKI ACCESSORIES
Grip heater lead wire Grip heater lead wire
9/15