Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade Copeland Guia De Instalacion

9. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware packs. Hold blade arm up to blade
and align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for the remaining
blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
[Note: Use slot located on switch housing plate
for easy access to motor screw holes with
screwdriver.] Before securing screws permanently,
repeat this procedure with remaining blade arms.
Securely tighten all screws.
Important: Tighten blade arm screws twice a
year.
10. Light Kit Assembly (Optional).
Remove 3 screws from outer edge of switch
housing plate (on underside of motor)--save
screws for later use.
If you wish to use fan WITHOUT the light kit,
connect female plug from switch housing to
male plug from motor housing, matching up the
colors on the male plug with the colors on the
female plug for correct fit. Align holes in switch
housing with holes in switch housing plate.
Re-insert screws that were previously removed
and securely tighten all 3 screws with a Phillips
screwdriver.
If you wish to use your fan WITH the light kit,
remove hex nut and lock washer from threaded
rod at top of light kit fitter. Punch center cap out
of switch housing with a screwdriver.
["Light Kit Assembly" continued on next
page.]
plastic
motor
lock
switch
housing
plate
lock washers
male plug
female plug
hex nut
lock washer
light
kit
fitter
page 7
motor housing
blade attachment
screws and washers
blade
blade arm
blade arm screws
motor housing
switch housing plate
switch housing
switch
housing
cap