G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER LBC 10 Documentación Técnica

1. Notes on Safety
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LBC
10.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with burrs and abrasives.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner AG, Industriestrasse 10, CH-5242 Lupfig,
hereby declares under sole responsibility that the prod-
uct with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. CH-Lupfig, 10/2019.
T. Fischer/Managing Division manager
2. Commissioning
2.1 P
rior to tAking the mAchine into service
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.2 t
Aking the mAchine into service
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
22
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 74.7dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
Grinding belt and non woven:
Belt length
Belt width
Belt thickness
Belt tension
Belt speed
Drive roller
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. handling / Operation
3.1 g
rinding belts
Use grinding belts only whose
max permitted speed is equal to or
higher than the machine's idle belt
speed!
Install clean grinding belts only.
3.1.1 A /d
ttAching etAtching the grinding belt
To change the grinding belt, first disengage the contact
arm.
max. 6.3bar
320W
0.65m /min
3
0.22m /min
3
about 2-3 drops/min
10000min
-1
0.8m/s , K=0.57m/s
2 2
3/4/4
1.020kg
520mm / 20 1/2"
3-19mm / 1/8"-3/4"
up to 4mm
40-90N
16m/s
Ø 30mm