Quick Installation - Tripp-Lite SmartPro AGSM5060 El Manual Del Propietario

Quick Installation

Plug the UPS into an outlet on a
1
dedicated circuit.*
NOTE! after you plug the UPS into a live AC outlet, the
UPS (in "Standby" mode) will automatically charge its
batteries,** but will not supply power to its outlets until
it is turned ON (see Step 3 below).
* Select models include an additional plug which can
be switched by a qualified electrician. ** The BATTERY
CHARGE LED will be the only LED illuminated.
2 Plug your equipment into the UPS.*
* Your UPS is designed to support only electronic
equipment. You will overload the UPS if the total VA
ratings for all the equipment you connect exceeds the
UPS's Output Capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is
listed in amps, multiply the number of amps by 120 to
determine VA. (Example: 1 amp × 120 = 120 VA). If
you are unsure if you have overloaded the UPS's
outlets, see "OUTPUT LOAD LEVEL" LED description.
3 Turn the UPS ON.
Press and hold the "ON/OFF/STANDBY" button
for one second. The alarm will beep once briefly
after one second has passed. Release the
button.
17-06-249-932406.indb 6
1
SMART2200RMXL2U plug
(NEMA 5-20P) shown
2
SMART3000RM2U shown
3
6
6/20/2017 4:49:14 PM