Mounting - Tripp-Lite SmartPro AGSM5060 El Manual Del Propietario

Mounting (Rack)
Mount your equipment in either a 4-post or 2-post rack or rack enclosure (see next page for
2-post mounting). The user must determine the fitness of hardware and procedures before
mounting. If hardware and procedures are not suitable for your application, contact the
manufacturer of your rack or rack enclosure. The procedures described in this manual are for
common rack and rack enclosure types and may not be appropriate for all applications.
4-Post Mounting
All UPS models include hardware required to mount in a 4-post rack. Select models include
an adjustable rack-mount shelf kit to provide additional support. If your UPS model does
not include an adjustable rackmount shelf kit, skip steps 1 and 2.
1
Connect the two segments of each shelf
the included screws and nuts
screws slightly loose so that the shelves can be
adjusted in the next step.
2
Adjust each shelf to fit your rack, then mount
them in the lowest available space of your rack
with the screws, nuts and washers provided
Note that the support ledges should face inward.
Tighten the screws that connect the shelf
segments .
B
3
Attach mounting ears
holes of your equipment
provided . The ears should face forward.
F
4
Using an assistant if necessary, lift your
equipment and slide it onto the mounting
shelves. Attach your equipment to the rack by
using the appropriate hardware
mounting ears and into the rack rails.
17-06-249-932406.indb 4
using
A
. Leave the
B
C
to the front mounting
D
using the screws
E
through its
G
4
B
A
1
C
.
2
E
D
3
G
4
B
F
6/20/2017 4:49:12 PM