Fan Assembly; Important - Craftmade Cortana CR52-LED Guia De Instalacion

5. Fan Assembly.

Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging ball
and remove stop pin and then slide hanging ball off of
the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable, electrical wires and antenna wire
through threaded end of downrod and pull extra wire
slack from the upper end of the downrod. [Refer to
diagram 2.]
Thread downrod into the motor housing yoke.
[WARNING: Do NOT begin threading downrod into yoke
if antenna wire is caught outside of the downrod/yoke
area. The antenna must go into the downrod along with
the wires.] Continue threading downrod until holes for
pin and clip in downrod align with holes in yoke--make
sure wires do not get twisted. Re-insert pin and clip that
were previously removed. Tighten yoke set screws and
nuts securely. [Refer to diagram 2.]
Locate canopy cover in hardware pack. Slide yoke cover,
scroll arm support (wide end up), downrod accessory
(wider end down), canopy cover (shiny side down) and
canopy over the downrod. [Refer to diagram 3.]
From top of motor housing, use sockets located inside
of motor housing to install 3 candelabra base 4 watt LED
bulbs (included). [Refer to diagram 3.]
Tip: Do not touch glass portion of bulbs with fingers or
hands. Oil from skin can cause bulbs to overheat and go
out prematurely. Use cardboard box or foam wrapping
bulbs were packed with to layer around glass portion of
bulbs.
IMPORTANT: When replacing bulbs, please allow bulbs
and motor housing to cool down before touching and
remember not to touch the glass portion of the bulbs
as described above (see "Tip").
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw hole;
use this hole when setting the set screw. Insert stop
pin into top of downrod and raise hanging ball. Be sure
stop pin aligns with slots on the inside of the hanging
ball. Tighten set screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw completely
could result in the fan becoming loose and possibly
falling.
set screw
diagram 1
electrical wiring
downrod
clip
diagram 2
canopy cover
downrod
accessory
bulb
diagram 3
stop pin
diagram 4
page 4
stop pin
hanging ball
safety cable
yoke set screw
and nut
downrod
canopy
scroll arm
support
yoke cover
motor housing
set screw hole
hanging ball
canopy
pin