Remote/Wall Control Operation; Testing Your Fan - Craftmade Cortana CR52-LED Guia De Instalacion

14. Remote/Wall Control Operation.

handheld
remote control
2
III IV
1
II
I
4
1--Fan SPEED control button(s):
2--Fan OFF button:
3--REVERSE function button:
4--LIGHTING button:
5--ON/OFF slider switch:
IMPORTANT
: The Automated Learning Process takes approximately 5 minutes to complete. Please
leave the fan "ON" for the duration of the 5-minute programming and do NOT use the
remote control or turn the power off during this time.
The fan will cycle through ALL SIX (6) speeds in forward and reverse and will then stop
automatically after the learning process is complete.

15. Testing Your Fan.

It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test wall
control (optional installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light function and test fan
speeds. Locate handheld remote control. Test fan speeds with the
different fan speed buttons (I - VI) on handheld remote control. Test
the light ON/OFF function by pressing the
control operates all of the functions of the fan/light, battery has been
installed correctly. If the wall and/or remote control do (does) not
operate all of the fan/light functions, refer to "Troubleshooting" section
to solve any issues before contacting Customer Service.
Fan must be on LOW before setting the fan in reverse. Use
to recirculate air depending on the season. A ceiling fan will allow you
to raise your thermostat setting in summer and lower your thermostat
setting in winter without feeling a difference in your comfort.
NOTE: If the wall control/handheld remote control interferes with other
appliances, activate a new code on the wall control/ handheld remote
control by turning the power off first. Go back to the instructions for
the SET button in Section 13 (page 9).
IMPORTANT: Handheld remote control and wall control must be
synchronized with fan in order to properly function.
IMPORTANT:
Handheld remote
control and wall
control must be
V
SYNCHRONIZED with
VI
fan in order to
properly function.
Use to control the ceiling fan speed 1-6
Use to turn the fan off
Use to control fan direction
Use to control down-light and up-light (if applicable)
[Wall control only] Use to turn wall control on or off
button. If the remote
button
page 10
wall control
2
III IV
1
II V
I VI
3
5
OFF ON
III IV
II V
VI
I
4