Canopy Assembly; Blade Assembly - Craftmade Cortana CR52-LED Guia De Instalacion

9. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.

10. Blade Assembly.

WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Partially loosen 3 screws in outer edge of motor
plate (located on underside of motor housing).
Next, remove 2 screws from fitter plate inside
motor plate; remove fitter plate. Save screws and
fitter plate for later use.
Remove blade arm screws/lock washers from
underside of motor. [NOTE: Use slot located on
motor plate for access to blade arm screws with
screwdriver.] Align blade arm holes with motor
screw holes and attach blade arm with blade
arm screws/lock washers. Before securing screws
permanently, repeat with remaining blade arms.
Securely tighten all screws.
IMPORTANT: Tighten blade arm screws twice a
year.
screw
canopy
fitter
plate
page 7
hanging
bracket
screw
canopy cover
motor
housing
motor plate
blade attachment
screws and washers
blade arm
blade arm screws/
lock washers
blade