Gorenje Tiki OGB 30 SEDD/UNI Instrucciones página 14

Protection against freezing:
- Use the key and select the
- The regulator is set to temperature 7ºC – shown on the display
Cost saving operating mode:
- Use the key and select the
- The regulator is set to temperature 55ºC – shown on the display
Manual temperature setting:
- Use the key and select the
- The display always shows the last setting of the water temperature; except on first turn on
of appliance when factory setting 35ºC is displayed.
- Use the or
decrease the temperature by 1ºC. Holding the key will speed up the process.
- After required temperature is set display flashes for 3 seconds and then shows the current
temperature again.
- In case of interruptions in power supply, the appliance resumes operating with the settings
adjusted before the interruption.
INDICATION:
• Control lamps:
- Heating element operation
- Mg anode
- Water heater operation: Yellow control lamps:
14
operating mode (yellow control lamp under
operating mode (yellow control lamp under
operating mode (yellow control lamp under
key to select new temperature. By pressing the key you increase/
- the heating element is on – the lamp is on
- the heating element is off – the lamp is off
: Red control lamp:
- the lamp is off – anode is active
- the lamp is on – anode may be worn out
Warning! When the water heater is out of use for longer
period of time, the signal lamp may indicate that the Mg
anode is worn out in spite of the fact that the Mg anode
is still active. In this case open the hot water tap (fresh
water flow into water heater). If the signal lamp switches
off, the water heater operation is not impaired. If not, call
the nearest authorized service provider
- protection against freezing – the lamp is on or
- cost saving temperature setting – the lamp is on or
- manual setting– the lamp is on
: Green control lamp:
is on)
is on)
is on).