Chauvin Arnoux C.A 10141 Guia De Inicio Rapido página 3

RESISTIVITY MEASUREMENT


> 2s
SET
TDS MEASUREMENT
 
x 2
> 2s
SET
SALINITY MEASUREMENT


x 3
> 2s
SET
FRANCE INTERNATIONAL
Chauvin Arnoux Group Chauvin Arnoux Group
190, rue Championnet Tél : +33 1 44 85 44 38
75876 PARIS Cedex 18 Fax : +33 1 46 27 95 69
Tél : +33 1 44 85 44 85
Fax : +33 1 46 27 73 89 Our international contacts
info@chauvin-arnoux.com www.chauvin-arnoux.com/contacts
www.chauvin-arnoux.com
695718A00 - Ed. 1 - 11/2018 © Chauvin Arnoux - All rights reserved and reproduction prohibited

USER'S MANUAL
Visit our web site to download the operating instructions for
your instrument and your cell:
www.chauvin-arnoux.com
Go to the Products tab and search on the name of your
instrument. When you have found the instrument, go to its
page. The operating instructions are on the right.
cor lin
Download them.
Proceed in the same way for the conductivity cell.
ATC
Ref 20°C
INSERTING THE BATTERIES
cor lin
ATC
Ref 25°C
cor lin
ATC
DATA LOGGER TRANSFER SOFTWARE
Visit our web site to download the latest version of the ap-
plication software:
www.chauvin-arnoux.com
Go to the Support tab, then Download our software. Then
search on the name of your instrument.
Download the software, then install it on your PC.
GETTING STARTED GUIDE TO THE C.A 10141 (GB)
 


 
KEYS
Key Function
On/Off key (long press)
„ MEM: a short press to record the measure-
MEM
ment and the temperature.
REC
„ REC: a long press to start or stop recording.
: a short press to select the type of
„
measurement: conductivity, resistivity, TDS,
or salinity.
„ SET: a long press to change the parame-
terizing of the measurements: the unit of
SET
temperature, the temperature correction,
the reference temperature, the TDS factor.
A second long press to exit from the param-
eterizing of the measurements.
Backlight.
„ CAL: a short press to look up the calibration
CAL parameters and start a calibration.
END „ END: a long press to terminate the cali-
bration.
▲ „ A short press to set the temperature in MTC
or the parameters in SET mode.
▼
„ A long press to select the standard solution
during the calibration.
DELIVERY CONDITION
The C.A 10141 conductivity meter is delivered in a carrying
case with:
„ One XCP4ST1 conductivity cell with integrated temper-
ature probe.
„ Four AA or LR6 alkaline batteries.
„ One protective sheath fitted on the instrument.
„ One standard solution having a conductivity of 1408µS/cm.
„ One beaker.
„ One USB to micro USB cable.
„ One wrist strap.
„ Getting started guides (one per language).
„ One certificate of verification.