Installation Instructions - HAMPTON BAY 480-997 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS:
1. Carefully unpack the fixture. Lay out all parts on a clean surface.
2. Screw the middle column (#16) to the fixture (#19). Using the Quick Link (#14), attach the chain (#15) to the middle column
(#16).
3. Thread the fixture wires up through the middle column (#16), weave the wire through every third link of the chain (#15),
through the loop ring (#13), through the screw collar loop (#12), through the canopy (#11) and through the threaded nipple (#9)
on the mounting strap (#4).
4. Install five 60 watt candelabra (B10.5) base incandescent light Bulbs (#18).
5. Place the Shades (#18) with clip.
ASSEMBLY:
Loop
Loop

INSTALLATION INSTRUCTIONS:

1. Attach the Mounting Strap (#4) to the Outlet Box (#1) using the two outlet box Screws (#10).
2. Adjust the chain (#15) to required height by lifting the fixture and attaching the Quick Link (#14) to a link of chain (#15)
closer to the ceiling. The fixture can be raised and lowered in this manner until the desired height is achieved. Next, use pliers
to twist open (cover the chain with cloth to prevent damage) the first unused link of chain (#15). Remove and save the excess
chain. Pull the excess fixture wires through the nipple (#9) into the outlet box (#1). Wires may be left at full length or
shortened depending on how much space you have in the outlet box (#1).
3. Wrap the ground wire from the fixture around the Ground Screw (#5) on the Mounting Strap (#4), and then connect the ground
wire from the fixture to the ground wire from the Outlet Box (#1). Connect the wire without writing on it (with raised ribs)
from the fixture to the white wire (neutral wire) from the Outlet Box (#1). Connect the wire with writing on it (smooth wire)
from the fixture to the black wire (live wire) from the outlet box (#1). Cover the connections using the wire connectors (#2).
Wrap the wire connections/connectors (#2) with electrical tape to ensure the connections will not come apart. Position the
wires back inside the outlet box (#1). Note: If you have electrical questions, consult your local electrical code for approved
grounding methods or seek the advice of a qualified licensed electrician.
4. Place the canopy (#11) over the nipple (#9) all the way to the ceiling. Screw the loop ring (#13) onto the screw collar loop
(#10) until the Canopy (#11) is held firmly against the ceiling.
5. Installation is now complete. Turn on the power at the circuit breaker or fuse box. Turn the light switch on to activate the
fixture.
#11 Canopy
#13 Loop Ring
#15 Chain
#12 Screw Collar
Loop
#3 Quick Link
Loop
#16 Middle Column
Loop
#19 Fixture
Loop
3
Lamp Distribution
(bottom view)
Loop
#14 Shade
Loop
60W Candelabra Bulb (B10.5)
Loop
Bulb Socket
Loop