Assembling And Mounting The Fan Blades - Fanimation Camhaven v2 FP8094 Serie Manual De Instrucciones

Assembling and Mounting the Fan Blades

1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a phillips screwdriver, tighten
3/16 -24 washer head screws and fiber washers to
secure the blade to the blade arm. (Figure 1)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Remove and discard the motor stops from the
motor assembly by removing the screws.
(Figure 2)
3. Secure the blade holders to the motor support
using the 1/4 -20 screws through the holes located
on the side of the motor support (Figure 3).
Periodically check blade holder hardware and
NOTE:
resecure if necessary.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
Blade Holder Arm
HARDWARE USED:
3/16 -24
WASHER HEAD
SCREWS
FIBER WASHER
Motor
Assembly
HARDWARE USED:
1/4 -20
Pan Head Screw
12
Blade
Figure 1
x 15
x 15
Motor
Stops
Figure 2
Pan Head Screw
(2 per blade holder)
Figure 3
x 10