Mopar 4280345 Manual Del Usuario página 18

18
81. Install the outer trim (1) and seat the retaining clips
fully.
82. Install the screw (1) back into the headlight switch cav­
ity.
NOTE: Before attempting to install the headlamp
switch (1), be certain that both pawl­like retainers (2)
are extended outward from the body of the switch.
If the retainers are in the retracted position, rotating
the headlamp switch rotary knob (4) to the OFF (O)
position should disengage the retainer retractor
mechanism causing the retainers to spring outward
from the switch body.
83. Position the headlamp switch (1) close enough to the
cylinder­like switch mounting hole in the instrument
panel to reconnect the instrument panel wire harness
connector to the connector receptacle (3) on the back
of the switch housing.
84. Position and align the switch in the center of the switch
mounting hole of the instrument panel.
85. Using hand pressure, press the switch firmly and
evenly into the mounting hole until it is fully seated.
An indication that the switch is fully seated will be a
light audible click as each of the two pawl­like retainers (2) snap into place within the mounting hole.
Nov 22, 2010
4280345
K6860941