Table Of Contents - Dremel 3D40 FLEX Traducción De Las Instrucciones Originales

3D40 FLEX may become damaged. Dremel
3D40 FLEX is intended to operate in temperature
between 16-29° C (60 - 85° F).
p. Do not move or bump Dremel 3D40 FLEX or the
extruder during operation. The object may build
incorrectly.
q. Do not change filament spool unless the
building process is completed, stopped, or
paused. Changing the filament during building will
cancel the object and may damage the extruder.
r. Do not pull the filament out until instructed
by the touch screen. Doing so may damage the
extruder.
s. Use extra care not to damage the extruder tip
when clearing debris. Dremel 3D40 FLEX will not
work properly with damaged extruder tip and will
require replacement.
t. Before every build make sure that the build
platform is covered with Dremel specified build
tape. Use of improper build tape may result in
equipment damage and poor object build quality.
u. Be aware of your body position when using
hand tools to remove objects from the build
platform. Sudden tool slip and improper body
position during object removal from the build
platform may result in personal injury.
v. Avoid scratching the build platform when
removing objects. Scratches in the build platform
will result in improper object creation.
w. Do not drop the build platform. Tempered glass
plate may break and result in personal injury.
x. Do not remove tempered glass plate from
plastic holder. Contact with tempered glass plate
edge may result in personal injury.
y. Do not twist or bend the build platform while
removing objects. Tempered glass plate may
separate from plastic holder and result in personal
injury.
z. Dremel is not responsible for structural integrity
or utility of objects created using Dremel 3D40
FLEX. Structural models created by inexperienced
designers may result in property damage and
personal injury.
SERVICE
a. Always unplug Dremel 3D40 FLEX from
its power before performing any service
procedures. Failure to do so may result in
personal injury and equipment damage.
b. Have your Dremel 3D40 FLEX serviced only by
an authorized Dremel service centre using only
Dremel replacement parts. This will ensure that
proper operation and safety of Dremel 3D40 FLEX
is maintained.
c. Use only Dremel approved materials and
components. Use of object materials, or 3D
objects other than Dremel
materials and genuine Dremel
void warranty.
d. Use only Dremel approved filament. Damage
to the product resulting from use of filament other
than Dremel approved filament is not covered
under warranty.
approved object
®
components may
®
370

TABLE OF CONTENTS

General safety warnings ..................................369
Table of contents...............................................370
Used symbols ....................................................371
FCC COMPLIANCE ..........................................371
Information on Intellectual Property ...............371
Functional Description and Specifications ....371
3D40 FLEX Resources ......................................372
Glossary of Terms .............................................373
Getting to know your 3D40 FLEX....................374
Introduction ........................................................376
Kit Contents*......................................................376
Touch Screen .....................................................378
Touch Screen Icons ..........................................383
Initial Setup ........................................................384
Getting Ready to Build .....................................385
INITIAL SETUP ...................................................387
Building ..............................................................390
Removing Your Object ......................................392
Best Practices ...................................................393
Maintenance .......................................................394
Maintenance and Service .................................396
Open Source Software .....................................397
Warranty .............................................................398