Configuration - Festo Compact performance CP-FB8-E Manual De Instrucciones

2

Configuration

Please note
The cover is connected to the internal PC boards via the
operating voltage cable. It cannot therefore not be
removed completely.
Caution
The node contains elements which are liable to damage
by electrostatic charges.
The node can also be destroyed if the contact surfaces
of plug connectors are touched, or if the regulations for
handling electrostatically vulnerable components are
not observed.
Please observe the following when configuring:
1. Switch off the operating voltage.
2. Open node (screws are liable to be lost).
3. Set fieldbus address.
4. Set fieldbus baud rate.
5. Close node.
6. If the CP system to be connected is at the end of a
fieldbus line, a terminating resistor must be installed.
12 Festo CP−FB8−E 0503e English