Sirona CEREC MC XL Manual Del Usuario página 54

2 Configuring the MC XL in the Ad-hoc mode
Configuring the "LINKSYS WET54G" WLAN module
Fig. 2-5 Ad-hoc mode Linksys setup
14
Operating MC XL via WLAN in the Ad-hoc mode CEREC / inLab MC XL
CAUTION: Change the IP address only in the following
cases:
new WLAN module or reset performed
After installing a new WLAN module or resetting the WLAN module, you must
determine the IP address and enter it into the fields "IP Address:".
The IP address of the milling unit WLAN module is the sum of the milling unit
IP address plus 100.
The IP address of the milling unit appears on the display after you switch the
milling unit on by pressing the "Config" button.
Example:
IP address of milling unit: 192.168.230.120
IP address of WLAN module: 192.168.230.220
9. Change the remaining settings as shown in the screenshot.
10. Click the "Apply" button.
11. Close all open windows at the end of the waiting period.
The configuration is now completed.
12. Remove the LAN cable.
Sirona Dental Systems GmbH
61 90 545 D 3439
D 3439.031.03.01.02 06.2007