Yamato SG 710 Manual De Instrucciones página 20

99524
WARNING: Make sure the blade does not touch the workpiece until the saw reaches its max speed set on the
speed Adjust Dial. Failure to comply could cause loss of control and result in serious injury.
Metal Cutting:
When cutting metallic material with this tool, be sure to use a sharp blade designed for this purpose. We
recommend lubricating the cutting surface with cutting oil to avoid heat buildup. Follow general cutting procedure
on previous page. Do not force tool. Use only enough pressure to keep the saw cutting.
Maintenance
• WARNING. Do not allow brake-fluids, gasoline, petroleum-based products penetrating oils, etc. Come in
contact with plastic parts. They contain chemicals that can damage, weaken or destroy the housing, thus
compromising the integrity of the double insulation.
•Inspecting the mounting screws.
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be
loose, tighten them immediately. Failure to do so could result in serious injuries.
•Maintenance of the motor.
The motor unit winding is the very "heart " of the power tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
•Inspection the carbon brushes
The motor employs carbon brushes which are consumable parts. Since an excessively worn carbon brush could
result in motor trouble, replace the carbon brush with an identical part when it becomes worn to or near the limit.
In addition, always keep carbon brushes clean and ensure that they slide freely with in the brush holder
WARNING: A set of spare carton brush is included in this package for replacement purposes. The check and
replacement of the brushes should only be performed by a qualified service technician using identical parts to
ensure the integrity of double insulation. To assure the safety of our customers, we strongly recommend against
the consumers checking and changing the brushes.
NOTE: Please read "WARNING" or previous section regarding checking and changing of the carbon brushes.
CAUTION: The brushes must always be replaced in pairs.
CAUTION: Always disconnect the machine from the power supply before removing any electrical covers.
Recycling
Meaning of crossed –out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact you local government for information regarding the collection systems available. If electrical
appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater
and get into the food chain, damaging your health and well-being.
20