Publicidad
Idiomas disponibles
Idiomas disponibles
S19-600, S19-610
Read this installation manual completely to ensure proper installation, then file it
Installation
with the owner or maintenance department. Compliance and conformity to drain
requirements and other local codes and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before
Packing List
•
discarding any packaging material. If any parts are missing, do not begin installation
•
•
T H
IS
E
•
S ID
U P
until you obtain the missing parts.
Flush the water supply lines before beginning installation and after installation is
complete. Test the unit for leaks and adequate water flow. Main water supply to the
eyewash should be "ON" at all times. Provisions shall be made to prevent unauthorized
shutoff.
The ANSI Z358.1 standard requires an uninterruptible supply of flushing fluid at a
minimum 30 PSI (0.21 MPa) flowing pressure. Flushing fluid should be tepid per ANSI
Z358.1.
The inspection and testing results of this equipment should be recorded weekly
to verify proper operation. This equipment should be inspected annually to ensure
compliance with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be
trained regarding the placement and proper operation of emergency equipment per
ANSI Z358.1.
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY
FAX: (262-251-5817)
http://www.bradleycorp.com
114-051
For questions regarding the operation or installation of this product, visit www.
bradleycorp.com or call 800.BRADLEY (800.272.3539).
Product warranties and service parts information may also be found under "Products"
on our web site at bradleycorp.com.
Supplies Required:
• Teflon tape and/or pipe sealant
• ½" NPT water supply piping
• (3) #8 flat-head screws (stainless steel recommended) and anchors
• Sign-mounting hardware
• Backflow prevention device as required by UPC, IPC and/or local plumbing codes
2
WARNING
3/11/10
Bradley Corporation • 215-314 Rev. K; ECM 09-05-0028
Installation
Publicidad
