Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
O-Ring
Bonnet
Screw
Stem
Adapter
Spline
Adapter
Stem
Adapter
Valve
Stem
Valve
Valve
Body
Body
4. Installing Cross Handles
Close the valves (hot = clockwise, cold = counterclockwise).
Lubricate each O-ring with water and position them on the
bonnet grooves.
Install a spline adapter to each valve stem.
Position a stem adapter on each spline adapter with the hex holes
in line with each other.
Install a gasket over each valve body.
Thread a bonnet onto each valve body.
Position a center cap over each stem adapter.
Insert a cross arm through the large hole in the center cap and
the hex holes in each stem adapter.
Align the holes in the cross arms and center caps.
Insert a long stud through the hole in each center cap.
Secure with the short stud.
Install the sleeves, washers, and end caps.
106386-2-AB
Gasket
Short Stud
Cross
Arm
Hole
6
Center Cap
Stem
Adapter
End
Cap
Sleeve
Washer
Long Stud
Kohler Co.
Publicidad
Tabla de contenido
