Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Screw
Bonnet
Stem
Adapter
Snap Ring
O-Ring
Spline
Adapter
Escutcheon
Gasket
Escutcheon
Valve Stem
Valve Body
5. Installing Lever Handles
Close the valves (hot = clockwise, cold = counterclockwise).
Position a gasket and escutcheon over each valve body.
Fit a spline adapter onto each valve stem.
Wet each O-ring with water.
Install a snap ring and O-ring in the grooves in each stem
adapter.
Position the stem adapters with the hex holes in-line with each
other.
Secure each stem adapter with a provided screw.
NOTE: To adjust the handle alignment, rotate the spline adapter.
Fit a sleeve and bonnet over each stem adapter.
Thread a bonnet to each valve body until they are tight against
the escutcheon.
Install a center cap to each bonnet.
Fit a long sleeve to each handle arm, and secure it with the end
cap.
Insert a handle arm through each center cap and bonnet.
Install a short sleeve and washer onto each handle arm and
secure them with the end caps.
Kohler Co.
Short
Sleeve
Sleeve
Center
Cap
Washer
Hex
Stem
Hole
Adapter
Bonnet
7
Center
Cap
Handle
Arm
Long
Sleeve
End
Cap
Bonnet
106386-2-AB
Publicidad
Tabla de contenido
