KPS -LX30LED Manual De Funcionamiento página 31

KPS-LX30LED • Digital light meter
buzzer beeping twice, and "AUTO" will appear on the middle of LCD display.
• Press and hold the KPS-LX30LED power key (4) for a short time to power
This indicates that the auto measurement mode is ON.
on the light meter. The LCD screen will illuminate (about 5 seconds) with the
will appear on the top left position of the LCD display, indicating that the
manual range switching mode has been activated.
• Press and hold the manual range switching key (9) for a short time; "MANU"
• In this mode, each time press and hold the key for a short time, the meter will
key for one second will result in the inscription "MANU" disappearing from
switch to 20.00Lux → 200.0Lux → 2,000Lux → 20,000Lux → 200,000Lux
topleft position of LCD display, replaced by "AUTO" appearing in the middle,
(or 20.00Fc → 200.0 Fc → 2,000 Fc → 20,000 Fc) in sequence; pressing the
to indicate that the meter has switched the manual range switching mode to
the auto range switchover.
activation of the relative value measurement mode. Press and hold the key
• Press and hold the REL/PEAK key (8) of the KPS-LX30LED for a short time,
"REL" will appear on the top left position of the LCD interface, indicating the
left position of the LCD interface will disappear.
(8) for a short time again, the device will exit the relative value measurement
mode and return to the original measurement mode, and "REL" on the top
Figure 4-1
31