Cleaning And Maintenance - Krups XP52 Serie Manual De Instrucciones

n Pour 60 to 100ml of cold fresh fat-free, low fat or whole milk in a small container that is about ½ litre
and can pass under the steam nozzle. The milk and its container should be quite cold.
n As soon as the indicator light stops blinking, plunge the steam nozzle into the milk.
n Turn the switch to the "steam" position (fig. 13).
n For a good result, hold the nozzle towards the bottom of the container for about 25 seconds while the
milk heats (without however touching the bottom of the container). Then, bring the container down
gradually so that the nozzle moves up towards the surface (without ever coming out of the milk) (fig.14).
n Once the froth has formed, turn the switch to the "stop" position (fig.15). The appliance will now
automatically cool itself by launching 3 intermittent pumping cycles. Once this automatic operation is
complete, you can make another coffee.
IMPORTANT:
To prevent the steam nozzle holes from being clogged, the milk foam must not
reach the black plastic upper part.
It is important to clean the steam nozzle after each use to prevent the milk from drying on the inside of
the nozzle. To do so:
n Place the steam nozzle in a container with water and repeat the milk frothing operation for 30 seconds.
ATTENTION!
The steam nozzle is still hot!
USING THE KRUPS XS-6000 AUTO-CAPPUCCINO SET TO FROTH MILK (SOLD SEPARATELY)
The auto-cappuccino accessory makes it easier to make a cappuccino or caffe latte. It consists of a
special dual-position nozzle and stainless steel milk container. This accessory may be sold separately from
your machine.
n Assemble all the different pieces. Choose the caffè latte or cappuccino position on the special nozzle.
n Fill up the milk container and place a cup or a glass underneath the special auto-cappuccino nozzle.
n Turn the switch to the "steam preheating" position.
n Once the light has stopped blinking, turn the switch to the "steam" position.
n Once the froth has been formed, turn the switch to the "stop" position. The appliance will now
automatically cool itself by launching 3 intermittent pumping cycles. Once this automatic operation is
complete, you can make another coffee.
To prevent the milk from drying on the auto-cappuccino accessory, we strongly recommend.
n pouring clean water in the container and re-assembling the various components
n starting a steam cycle
n clean all of the components with a damp cloth.

7. CLEANING AND MAINTENANCE

n IMPORTANT: Your espresso machine accessories are not dishwasher-safe. Do not wash the spoon,
drip tray, filter holder or water tank in the dishwasher.
CLEANING OF THE MACHINE
n Always unplug the machine before cleaning and allow it to cool down to avoid injury. Wipe the outside
of the machine with a clean damp cloth. Do not use harsh or abrasive cleaners, or alcohol/solvent-
based cleaners to clean the machine. Use only gentle dishwashing liquid and warm water. After each
use, rinse out the water tank and empty before replacing in the machine.
English
8