Precommissioning Indications - COPELE EQUIMATIC Manual De Instrucciones

3. Unscrew and remove the protective sheet of the programmer and lift the transparent
cover that protects the screen. The buttons of the programming terminal will be readily
available.
4. Setting the clock. Press HO and the (HORAS) [HOURS] LED light will turn on. Use
the ↑↓ push buttons to adjust time. Numbers will change faster if the buttons are
pressed for more than 3 seconds. To set the time, press HO again and the (HORAS)
[HOURS] LED light will turn off. Now the time can be seen on the screen.
5. Discharge frequency: The Equimatic hopper allows the user to apply three dosing
programs per day. To select the first program, press PR1 and the PROGRAMAS 1
[PROGRAMS 1] LED light will turn on. Use the
you want the feed to be delivered. To finalize the program, press Pr1 again and the
PROGRAMAS 1 [PROGRAMS 1] LED light will turn off. If you only want to use two
programs, set the third one at the same time as the second. If you only need a daily
discharge, set the three programs at the same time.
6. Adjusting the dose: If SEG [SEC.] is pressed, the MOTOR SEGUNDOS [MOTOR
SECONDS] LED light will turn on and the screen will show the number of seconds that
the motor will be working at the set time. Use the
and get the intended amount of feed. Finally, press SEG [SEC.] again and the MOTOR
SEGUNDOS [MOTOR SECONDS] LED light will turn off. The set duration is the same
for all three programs.
7. Memory. The programmer has a memory that can store the three programs and the
motor sequence in seconds. This memory will remain unaltered even if a power failure
occurs.

9.3. Precommissioning indications

After the desired adjustments are made, the unit will be ready to work following the steps
outlined below:
Do not try to initiate the machine before understanding how it works. If you read this manual
carefully and still have any query on how to control the machine during its operating stages, please
contact COPELE S.L.
INSTRUCTION MANUAL
COMMISSIONING
↑↓
push buttons to select the time when
↑↓
push buttons to adjust duration
Page 22 of 29