Translation of the original instructions
• Clean the device's surfaces with a soft, dry cloth.
Regulations :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
GENERAL DESCRIPTION
The NEOSTART range is designed to charge and start lead-acid batteries, 12V (6 elements) and 24V (12 elements) :
Assembling the handle and the wheels (only for the NEOSTART 420 et 620 ) :
POWER SUPPLY
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by
the machine. The device must be positioned so that the socket is always accessible.
The machine must be connected to a single phase socket (230 V) WITH earth protected by a 16A circuit breaker.
CONNECTION AND DISCONNECTION
IMPORTANT ! Before any connection to a vehicle battery, make sure that the booster isn't connected to the mains and
that the booster's switch is set to OFF (if applicable).
Also, check the battery polarity.
Warning : the cables must not be kinked or in contact with hot or sharp surfaces.
• Disconnect any electronic system from the battery during the charge (do not charge the battery when it's connectd
to the vehicle).
Start and charge a battery in-situ :
In the event that the negative terminal is plugged to the car's chassis :
• Connect the red clamp to the battery's positive + terminal.
• Connect the black clamp to the vehicle's chassis, make sure it is a safe distance from the battery and the fuel/exhaust pipe.
• Connect the device to the mains.
• After use, set the switch to OFF, disconnect the charger from the mains then remove the black clamp, followed by
the red clamp.
NEOSTART 320 / 420 / 620
Neostart 320
Neostart 420
Neostart 620
Recharge
40 - 400 Ah
25 - 600 Ah
45 - 900 Ah
Starting
35 - 120 Ah
35 - 160 Ah
45 - 200 Ah
EN
11