Troubleshooting - Indesit SI61W Guía Rápida

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 9

TROUBLESHOOTING

What to do if...
The appliance doesn't work.
The inside light does not
work.
The internal temperature
of the compartments is not
cold enough.
There is water on the
bottom of the refrigerator
compartment.
The front edge of the
appliance that the door
gaskets seal against is hot.
The temperature of the
refrigerator compartment is
too cold.
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
Visiting our website
Using QR Code
Alternatively,
contacting our After-sales Service, please state the codes provided on your product's identification plate.
Possible reasons
There may be an appliance power
supply problem.
It may be necessary to replace the light
bulb.
The reasons could vary (see "Solution")
column.
The defrost water drain is blocked.
This is not a problem. It prevents
condensation from forming.
The set temperature is too cold.
A large amount of fresh food may
have been placed in the freezer
compartment.
docs . indesit . eu
contact our After-sales Service
Solutions
Make sure:
there is not a power failure;
the plug is properly inserted in the power socket and the double-
pole switch (if present) is in the correct position (on);
the household electrical system protection devices function;
the power cable is not broken;
the thermostat knob is not turned to "
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
Check that:
the doors are closed properly;
the appliance is not installed near a heat source;
the temperature is appropriately set;
the circulation of air through the ventilation grilles on the base of
the appliance is not obstructed.
Clean the defrosting water drain (see section "Cleaning and
Maintenance").
A solution is not needed.
Try to set a less cold temperature.
If fresh food has been put in the freezer compartment, wait until
the freezing has been completed.
Turn off the fan (if present) described in the paragraph "FAN".
(See phone number in the warranty booklet). When
".

Publicidad

Tabla de contenido
loading

Tabla de contenido