Care And Cleaning; Troubleshooting - Defiant DF-5909-WH Guía Para El Uso Y Cuidado

Care and Cleaning

□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.

Troubleshooting

Problem
The light will not come
on.
The light comes on
during the day.
The light comes on for
no apparent reason.
Possible Cause
□
The motion sensor is not angled
correctly.
□
The light switch is turned off.
□
The fuse is blown or the circuit breaker
is turned off.
□
The light fixture is not properly
attached to the mounting plate, if this is
a new installation.
□
The ON-TIME switch is set to 5 or 20
so the daylight turn-off (photocell) is
in effect.
□
The circuit wiring is incorrect (if this is
a new installation).
□
The motion sensor is aimed in the
wrong direction.
□
The outside air temperature is close to
the same as a person's body heat.
□
The motion sensor may be installed in a
relatively dark location.
□
The "ON-TIME" setting is set to "TEST".
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The "SENS" setting is set too high.
□
The "DUALBRITE" setting is in the 5
hour or D2D (dusk-to-dawn) setting.
□
The outside temperature is much
warmer or cooler than a person's body
heat (summer or winter).
□
The light fixture is wired through a
dimmer or timer.
Solution
□
Rotate the motion sensor correctly
(see step 2 under Operation).
□
Turn the light switch on.
□
Replace the fuse or turn the circuit
breaker on.
□
Re-install the light fixture to the
mounting plate (see steps 5 and 6
under Installation).
□
Recheck after dark or use the TEST
feature (see steps 3 and 4 under
Operation).
□
Verify the wiring is correct (see steps
2 and 3 under Installation).
□
Re-aim the motion sensor to cover
the desired area.
□
Increase the "SENS" setting.
□
The light fixture is operating normally
under these circumstances.
□
Set the "ON-TIME" setting to the 5 or
20 minute setting.
□
Decrease the "SENS" setting or
reposition the motion sensor.
□
Decrease the "SENS" setting.
□
The light fixture is operating normally
under these circumstances. Set
"DUALBRITE" to OFF if no accent
lighting is desired.
□
Decrease the "SENS" setting.
□
Do not use a dimmer or timer to
control the light fixture. Replace the
dimmer or timer with a standard on/
off wall switch.
11
Please contact 1-866-308-3976 for further assistance.
HOMEDEPOT.COM