Defiant DF-5909-WH Guía Para El Uso Y Cuidado página 9

Operation (continued)
3
Setting the sensor for testing
NOTE: When the "ON-TIME" is set to the "TEST" position,
the light fixture will operate during the day or night. The
light will stay on for 5 seconds after all motion is stopped.
Press the button next to each setting until the light
next to the desired setting begins to flash. Stop
pressing the button and the light will stop flashing
momentarily.
□
Press the "ON-TIME" button until the "TEST"
light flashes.
□
Press the "SENS" button until the "Low" light
flashes.
□
Ensure the "DUALBRITE" feature is set to the
"OFF" position.
□
The above settings will be used for step 4
(Adjusting the Motion Sensor Detection Zone).
4
Adjusting the motion sensor
detection zone
□
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
□
Watch the light. The light will come on when
motion has been detected.
□
Stop, wait for the light to turn off, and then
begin walking again.
□
Continue this process to determine if the
motion sensor (C) is aimed toward the desired
area.
□
If needed, gently grasp the motion sensor (C)
and move it from side to side or up and down
to adjust the detection zone.
5
Adjusting the ON-TIME
NOTE: When the "ON-TIME" button is set to the 5 or 20
minute position, the light will only come on during the
night. The "ON-TIME" button determines the amount of
time the light will stay on full bright after all motion has
stopped.
□
Press the "ON-TIME" button until the desired
time light flashes (5 or 20 minutes).
C
DUALBRITE SENS DUALBRITE
9
DUALBRITE
DUALBRITE
ON TIME SENS DUALBRITE ON TIME
TEST 5 Minutes
Please contact 1-866-308-3976 for further assistance.
SENS ON TIME
SENS ON TIME
C
SENS ON TIME
20 Minutes
HOMEDEPOT.COM