Power Cable - Omcan BC-IT-0103-T Manual Del Usuario

If the appliance is inactive for long periods of time proceed as follows: turn the main switch to the OFF position.
Remove the plug from its socket. Empty the appliance and clean. Leave the door half-open to avoid creation of
bad smells. Protect the compressor group from dust.
CORE PROBE
Clean well the edge for the first use of it, and after every use. If it's not in use, after cleaning, cover with its
rubber cap and place it in the proper side, within the appliance's chamber.
CONDENSING COIL
It is important that the coil is capable of offering the maximum possible heat exchange. It is therefore important
that its surface be always free of dirt or dust that may be deposited by the effect of the fan's operation. Use
a vacuum cleaner and soft bristled brush to remove all the impurities such as paper or dust that may have
deposited on the coil. Check that the aluminium fins have not been damaged or bent; if this is the case "comb"
the coil with the appropriate tool until the original condition is regained to optimize the air flow.
Note: Failing to clean the condenser or not leaving at least six inches from the back of the unit to the
wall will void the warranty.

POWER CABLE

Check that the power cable that connects the appliance to the mains socket is not cut, cracked or altered
in such a way as to compromise the insulation. Contact your authorised service centre if this requires
maintenance.
ALARMS
The alarms will be displayed on the Home page if the effect is to interrupt
or to prevent the activation of the cycle. If they are such as to allow the
continuation of the cycle in progress they will instead take the place of the
"cycle progress bar" until they disappear.
17
Maintenance