Autopilot PX2 Instrucciones página 5

ZONE A SETUP
Press to cycle through the following
options: Zone A Setup; Zone A Output
Schedule; Zone B Setup; Zone B Output
Schedule; and System Setting.
NOTE: If there is no activity for 15
seconds while setting up, the controller
will automatically go back to the HOME
page.
All settings must be saved by pressing
for the controller to operate.
and enter the ZONE A menu.
1. Press
2. Press to cursor through the values and highlight the value you want to change.
Value Description
Type Type of lights installed in ZONE A (or B): 250W, 315W, 400W, 600W, 630W,
750W, 945W, 1000W HPS/CMH, 320W LED, 480W LED, 600W LED, 640W LED,
680W LED, 2x315W, 2x600W.
Power Select percentage or wattage for the fixtures.
R/S
(0–30 min) The time lights will take to gradually reach full power (R=sunrise) or
turn off (S=sunset).
Dim The temperature limit at which the lights will auto-dim.
Stop The temperature limit at which the lights will auto-shutdown.
Delay (0–30 min) Hot start prevention to allow HID lamps adequate time to cool to
prevent lamp damage. For HID, minimum setting should be 15 min. For LED,
setting can be 0 min.
3. Press or
4. Repeat steps 2–3 to set all values.
5. Press to save the settings.
6. Repeat steps for ZONE B.
INSTRUCTIONS
to select the correct setting, then press to confirm.
5