Complete The Installation - Kohler K-8802 Guia De Instalacion

Lift Rod
Ball Lever
Connecting
Assembly
Link
V-Clip
Approximately
1/2" (1.3 cm) of
Clamping
the lift rod should
Screw
be exposed.

4. Complete the Installation

From underneath the sink:
Loosen the clamping screw from the clamping link of the ball
lever assembly. Do not completely remove the clamping screw.
Rotate and align the holes of the connecting link to the lift rod.
Insert the lift rod through both holes of the connecting link.
Approximately 1/2" (1.3 cm) of the lift rod should be exposed
from the bottom of the connecting link.
Securely tighten the clamping screw.
Lift and hold the rod of the ball lever assembly upward.
Securely tighten the tailpiece onto the strainer body.
From above the sink:
Align the open edge of the stopper with the rod of the ball lever
assembly inside the tailpiece, as illustrated.
Rotate the stopper clockwise until the stopper locks into place
onto the rod of the ball lever assembly.
Push the lift knob down to release the stopper.
Place the strainer on top of the stopper.
110468-2-A
Strainer
Stopper
Align slot of
stopper assembly
Ball Lever
with rod lever and
Assembly
turn clockwise.
6 Kohler Co.