Troubleshooting; Installation; Safety; General Safety Instructions - Stiebel Eltron DHX 3.5-1 Trend Funcionamiento E Instalación

INSTALLATION

Troubleshooting

7. Troubleshooting
Problem Cause
The water heater will not There is no power
start despite the DHW
valve being fully open
The aerator in the tap or
the shower head is scaled
up or dirty
The water supply has
been interrupted
When hot water is being The air detector detects
drawn off, cold water air in the water. It switch-
flows for a short period es off the heating output
briefly
The required temperature Internal anti-scalding pro-
cannot be set tection is active
If you cannot solve the problem, contact your qualified contractor.
To facilitate and speed up your inquiry, please provide the serial
number from the type plate (000000-0000-000000). For live technical
assistance, please contact us at 800.582.8423. Alternatively, you may
email us at info@stiebel-eltron-usa.com
www.stiebel-eltron-usa.com
Solution
Check to ensure circuit
breaker in breaker panel
hasn't tripped. Reset if
necessary
The white AE3 safety
switch has not been
engaged during initial
startup. Activate if neces-
sary (See section 12.2.1,
"Initial AE3 safety switch
activation," pg. 18). If
the AE3 switch has tripped
after initial installation,
contact a qualified con-
tractor to fix the cause
Clean and/or descale the
aerator or shower head
Vent the water heater and
the cold water inlet line
The water heater restarts
automatically after 1 min-
ute
The internal anti-scalding
protection can only be
adjusted by qualified con-
tractors
Nr.: 000000-0000-00000
INSTALLATION
8.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the water heater.
8.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the water heater
are used.
Material losses
!
Observe the maximum inlet temperature. Higher tempera-
tures may damage the water heater. You can limit the max-
imum inlet temperature by installing a central thermostatic
valve.
WARNING Electrocution
This water heater contains capacitors which are discharged
when disconnected from the power supply. The capacitor
discharge voltage may briefly exceed 60 V DC.
8.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
- The electrical resistivity of the water must not fall below that
stated on the type plate. In a linked water network, factor in
the lowest electrical resistivity of the water. Your water supply
utility will advise you of the electrical resistivity or conductivity
of the water in your area.
9.

Water heater description

9.1

Standard delivery

The following are delivered with the water heater:
- Filter screen, factory installed in cold water inlet
- Jumper for anti-scalding protection, attached
- Jumper, spare, attached
- 2 x mounting screws
- 2 x wall anchors
- 0.5 gpm (1.9 l/min) flow-reducer/aerator [DHX 3.5-1 Trend
only]. See section 11.3, "Aerator installation at connected fau-
cet," pg. 16, for more information.
- 1.0 gpm (3.8 l/min) flow-reducer/aerator [DHX 6-2 Trend only].
See section 11.3, "Aerator installation at connected faucet," pg.
16, for more information.
DHX Trend & DHX Plus | 13