Replacing The Neck Liner; Shortening The Spiral Liner - Abicor Binzel FCAW Instructivo De Servicio

Antorcha de soldadura alpha flux
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10 Troubleshooting

9.3.1 Replacing the neck liner

9.3.2 Shortening the spiral liner

10 Troubleshooting
EN - 14
 See Fig. 2 Mounting the neck liner on page EN-8
1 Unscrew the clamping screw at the handle, remove the torch neck (1) and
pull out the old neck liner (3).
2 Insert the new neck liner from the rear into the torch neck (1) up to the stop
and measure the length.
3 Shorten the neck liner at the front side until the inlet nipple (2) terminates
flush at the torch neck (1) and debur the edge.
4 Slide the torch neck (1) into the handle as far as it will go and secure it with
the clamping screw.
 See Fig. 3 Mounting the liner on page EN-9
NOTICE
• New still unused liners have to be shortened to the actual length of the
cable assembly.
1 Lay down the cable assembly straight.
2 Unscrew retaining sleeve (6) / clamping bolt (7).
3 Insert the new liner (5).
4 Measure the excess length of the liner:
• subtract 15 mm in case of a central connection
• add 1 mm in case of a Lincoln connection
5 Pull out liner (5).
6 Shorten the front side of the liner by the calculated length
7 Debur the edge
8 Insert the liner (5).
9 Tighten retaining sleeve (6) / clamping bolt (7).
NOTICE
• If the measures described below are not successful, please consult your
dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as power supply, wire feeder, etc.
ALPHA FLUX

Publicidad

Tabla de contenido
loading

Tabla de contenido