HAMPTON BAY 48-LG Guía De Uso Y Mantenimiento página 10

Assembly - Hanging the Fan (continued)
7
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the mounting bracket.
□
Secure with electrical tape.
8
Mounting the fan
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the slide-on mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
□
Align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (HH).
□
Install the remaining two mounting screws (II) into the holes
in the canopy (C) and tighten firmly.
□
Install the decorative canopy ring (JJ) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
A
II
HH
JJ
C
D
10
Close-to-Ceiling Mounting
WARNING: The locking slots of celling canopy are provided only
as an aid to mounting. Do not leave the fan assembly undattended
until all four canopy screws are engaged and firmly tightened.
□
Carefully unhook the fan from the slide-on mounting bracket
(A) and align the locking slots of the ceiling canopy (C) with
the two screws (HH) in the slide-on mounting bracket (A). Push
up to engage the slots and turn clockwise to lock in place.
Immediately tighten the two mounting screws (HH) firmly.
□
Install the remaining two mounting screws (II) into the holes in
the canopy (C) and tighten firmly.
□
Install the decorative canopy ring (JJ) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
□
You may now proceed to attaching the fan blades.
A
II
HH
JJ
C
D