Charcoal Filter; Troubleshooting Tips - GE PVM9005 El Manual Del Propietario

Care and Cleaning

Charcoal Filter

The charcoal filter cannot be cleaned. It must be
replaced. See back cover for ordering online at
GEAppliances.com.
If the model is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that
helps remove smoke and odors.
The charcoal filter should be replaced when it is
months, depending on usage). See Optional Kits page
22, for more information.

Troubleshooting Tips

Problem Possible Cause
Oven will not start A fuse in your home may be blown or the circuit breaker tripped.
Power surge.
Plug not fully inserted into wall outlet
Door not securely closed.
Control panel lighted, yet Door not securely closed.
oven will not start
START/PAUSE button not pressed after entering cooking selection.
not pressed to cancel it.
CONTROL LOCKED The control has been locked.
appears on display
Floor of the oven is warm The cooktop light is located below the oven floor. When light is on,
even when the oven has the heat it produces may make the oven floor get warm.
not been used
You hear an unusual low- You have tried to change the power level when it is not allowed
tone beep
Vent fan comes on The vent fan automatically turns on to protect the microwave if it
automatically senses too much heat rising from the cooktop below.
Bluetooth Power interruption may disrupt bluetooth connection
connection not paired
49-7000118 Rev. 0
CHARCOAL FILTER REPLACEMENT
1. Unplug the microwave oven.
2. Remove the vent grille mounting screws.
3. Tip the grille forward, then lift out to remove.
4. Remove the charcoal filter.
5. Slide a new charcoal filter into place.
Slide the bottom of the vent grille into place.
Push the top until is snaps into place.
Replace the mounting screws
7. Plug in the microwave oven.
What To Do
• Replace fuse or reset circuit breaker.
• Unplug the microwave oven, then plug it
back in.
• Make sure the 3-prong plug on the oven is
fully inserted into wall outlet.
• Open the door and close securely.
• Open the door and close securely.
• Press START/PAUSE.
• Make sure you have entered cooking time
• Reset cooking program and press START/
PAUSE.
3 seconds to unlock the control.
• This is normal.
• Many of the oven's features are preset and
cannot be changed.
• This is normal.
CONNECT process on the GE Appliances
button for 3 seconds on the
microwave. This will restart the pairing
process. If this does not work, unplug unit
or reset the circuit breaker to reset the
control.
19