Installation Instructions
C4
MOUNT
THE OVEN
(continued)
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engagec. (It will be completely
tightened later.)
Cabinet Front
L
Cabinet Bottom Shelf
Self-Aligning Screw
Oven Top
Insert 3 self-aligning screws
(%4"-28 x 254") through outer
top cabinet holes. Turn two full
turns on each screw.
Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
Install grease filters. See the Owner's Manual
packed with the oven.
22
C5
INSTALLING THE CHARCOAL
FILTER
Remove 2 screws on top of oven, just above
the grille panel, using a Phillips screwdriver.
Open the door.
Remove the grille.
Grille
Insert the filter into the oven as shown until it fits
squarely into place. It will rest at an angle behind
the front lower tabs. When properly installed,
the wire mesh of the filter should be visible
from the front.
Charcoal filter installed
Replace the grille and the 2 top screws.
[6 | Close the door and replace left side screw.