ELICA ÉDITH ROCK Montaje Y Modo De Empleo página 35

Maintenance
Before performing any maintenance operation, isolate the
hood from the electrical supply by switching off at the
connector and removing the connector fuse.
Cleaning
The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Grease filter
Fig. 28-29-30
Traps cooking grease particles.
This must be cleaned at least once a month (or when the filter
saturation indication system - envisaged on the model in
possession - indicates this necessity), using non-aggressive
detergents, in a dishwasher, which must be set to a low
temperature and a short cycle (Tmax: 70°C).
When washed in a dishwasher, metal parts may discolour
slightly.
The filter must be dried in an oven for one hour at a max
temperature of 100°C; if the filter is still moist, repeat the
operation.
Replace the filter at least every 2 years.
Attention! After having performed maintenance on the filter,
FIRST install the grease filter in the specific container and
THEN the charcoal filter. The latter can be recognised as it is
sealed inside a braiding.
Once the container has been repositioned, make sure only the
grease filter is visible.
Charcoal filter (filter version only)
Fig. 28-29-30
It absorbs unpleasant odours caused by cooking.
Attention! The active charcoal filter can be recognised as it is
sealed inside a braiding. Perform disassembly, maintenance
and cleaning operations of the filter, managing it with the
utmost care to avoid damaging or opening the braiding.
The charcoal filter can be washed once every two months (or
when the filter saturation indication system – if envisaged on
the model in possession – indicates this necessity) using hot
water and a suitable detergent, or in a dishwasher at 65°C (if
the dishwasher is used, select the full cycle function and leave
dishes out).
Eliminate excess water without damaging the filter, then put it
in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
Attention! After having performed maintenance on the filter,
FIRST install the grease filter in the specific container and
THEN the charcoal filter. The latter can be recognised as it is
sealed inside a braiding.
Once the container has been repositioned, make sure only the
grease filter is visible.
Replacing lamps
Fig. 28
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
To purchase spare LEDs, contact the technical assistance
service.
35