Steelcase Answer Manual Del Usuario página 19

®
Boundary Screens
Single-Connect Single-Sided
Installation
1.
Place boundary screen on a clean,
scratch resistant surface.
2.
Install one (1) Answer attachment
clip with four (4) flat head wood
screws (provided) (2a).
Install half wing bracket with ten (10)
flat head wood screws (provided) (2b).
3.
Place fence End-Of-Run (EOR) vertical
junction over Answer attachment clip and
slide up into position.
TIP: If desired, you can add a screw
(provided) into the Answer attachment clip
to further secure the boundary screen to
the fence EOR vertical junction.
4.
Place three (3) washers inside pocket
of fence EOR vertical junction and install
four (4) 1/4-20 x 1/2" truss head machine
screws (as shown).
5.
Install decorative cover as shown.
6.
Install glide as shown.
7.
Lift single-sided boundary screen fence
assembly up and assemble rest of assembly
as shown on page 4.
8.
Add two (2) flat head wood screws.
9.
Add support brackets to the Answer
structure, see page 19.
2a
SEE TIP
FENCE EOR
VERTICAL
1/4-20 x 1/2" TRUSS HEAD
JUNCTION
FENCE EOR
VERTICAL JUNCTION
3
5
ANSWER
ATTACHMENT CLIP
HALF WING
BRACKET
MACHINE SCREW
WASHER
4
DECORATIVE
COVER
6
2b
8
Page 19 of 28
P/N 1115992001
Doc # 90255 Rev D