Kohler CORALAIS T-15880 Instrucciones De Instalación página 4

Insert valve bodies through mounting holes from bottom
of deck. Hold in place.
Thread a sidebody extension onto each valve body until
sidebody extension bottoms out on valve body.
Ensure sidebody extensions are resting inside valve body
deck holes and not skewed out of holes.
SUPPLY TUBE CONNECTION
Measure distance from bottom of spout supply tube to top
of tee.
Add 1" (2.5cm) to this measurement and cut a piece of
1/2" nominal (5/8" O.D.) copper tubing to fit into the supply
tube and tee port.
Pivot the valve bodies enough to remove the tee and two
pieces of tubing. (It may be necessary to remove the
entire valve body assembly.)
Clean and flux ends for all tubing connections.
Install the three copper tubes into the tee. Mate copper
tube from tee with spout supply tube. Pivot the valve
bodies onto the two horizontal pieces of copper tubing.
Ensure cold supply is on right hand side.
DO NOT solder at this time.
Ensure sidebody extensions are resting inside valve body
deck holes and not skewed out of holes.
Tighten sidebody extensions with adjustable pliers.
Tighten mounting nuts on each valve body underneath
deck.
Solder copper tubes to valve bodies, tee and spout supply
tube.
RIM MOUNT INSTALLATIONS: Install bath now per
installation instructions provided with bath.
Solder hot and cold water supply tubes to valve body
inlets.
Kohler Co.
Sidebody
Extension
Valve Body
Measure
Distance
Rough
Deck
Mounting
Nut
Hot Valve
Body
Copper Tubing
Spout Supply Tube
Solder
Mounting Nut
Valve Body
Hot Supply
4
Deck
Fig. #5
Spout Supply Tube
Sidebody
Extension
Tee
Cold Valve
Body
Fig. #6
Mounting
Nut
Valve
Body
Cold Supply
Solder
Solder
Fig. #7
A
1011145-2-