Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTALLATION CHECKOUT (ALL INSTALLATIONS)
Thread 1/4" pipe plug into top of spout supply tube.
Ensure valves are closed (cold fully counterclockwise, hot
fully clockwise). Use a needle nose pliers to reach inside
the sidebody extensions to close the valves.
Turn on main water supply and check complete
installation for leaks with valves closed and open. Repair
as required.
Close both valves. Turn off main water supply.
WARNING: Risk
pressurized. Do not lean over pipe plug when
turning or removing the plug.
Wrap a towel around the pipe plug to prevent water spray.
Water will purge from the supply tube when you remove
the plug.
Carefully back out pipe plug to relieve pressure.
Thread pipe plug into spout supply tube. Leave pipe plug
installed until spout and handle installation.
Install cardboard plaster guards over both valves and
spout supply tube. Leave in place until spout and handle
installation.
For tile-in installations, install the spout sleeve assembly
and the brass washer with the round hole after the tile is
installed. Keep these parts in the poly bag until ready for
installation.
4. INSTALL TILE (TILED DECK INSTALLATIONS)
Verify that tile is no more than 1-1/4" (3.2cm) thick and that
deck is no more than 2-1/8" (5.4cm) thick. If not so, do not
install tile due to improper valving installation.
If proper clearance exists, install tile up to plaster guards
on valves and spout supply tube.
A
1011145-2-
of
injury.
Lines
will
1/4" Pipe Plug
CLOSE
HOT
be
Sidebody
Extension
Tile
Rough
Deck
5
CLOSE
COLD
Fig. #8
Spout
Supply
Tube
Fig. #9
Kohler Co.
Publicidad
Tabla de contenido
