Publicidad
Precision Router Table Fence Assembly
Step 3
Locate the Mounting Rail (#1) and slide it over the ¾" Hex Bolts (#5) as
shown. If you intend on using the Kreg Micro-Adjuster (sold separately),
position the mounting rail so it's fl ush with the front edge of the Table Mount.
If you do not plan on using the Micro-Adjuster, position the Mounting Rail so
it's fl ush with the back edge of the Table Mount. If necessary, apply pressure
to the top of the Mounting Rail as you tighten the bolts with a 7/16" wrench to
ensure the fence stays fl ush with the table top.
Note: If you are using a homemade or other type of router table top you should
only hand tighten the Bolts/Nuts down at this point. You will need to make
further adjustments before you can secure the assembly.
Step 4
Locate the Clamp Block (#2) and slide it onto the Mounting Rail (#1).
Thread two Nylon Set Screws (#29) into the front of the Clamp Block (as
shown) using a Flat-Head Screwdriver. The Nylon Set Screws should be
driven to the same depth until they just come in contact with the Clamp
Block. Back each of the Nylon Screws out 1/8 of a turn and lock them in
place using two 10-32 Hex Nuts (#32). These nylon set screws take the
'play' out of the fence and allows for more fl uid motion of the Mounting Rail.
Make adjustments as necessary.
Step 5
Locate the Fence Mount (#3) and align the four holes with the corresponding
holes on the Clamp Block (#2). Secure the two together using the four Brass
Washers (#17) and four ¼-20 x 3/8" Phillips Pan Head Machine Screws (#18),
without tightening completely. You will need to adjust the positioning of the
Fence Mount in Step 11 before tightening.
Note: If you're using a homemade or other type of router table, you must
align and secure the Mounting Rail and Clamp Block before starting this step.
Tighten down the four ¼-20 x ¾" Hex Bolts -- which you previously inserted
through the slotted holes in the Table Mount -- making sure the top edge of the
Clamp Block (#2) is fl ush or 1/32" below the surface of your router table top and
that the Clamp Block and Mounting Rail (#1) run perfectly parallel to the edge of
the table top.
Step 6
Next, attach the two Fence End Caps (#7) to each end of the Large Fence
(#4) using the eight ¼" nylon Snap Rivets (#21). These caps need to be
Curved
attached so the four curved notches on the end caps line up with the four
Notches
curved notches on the Large Fence.
Step 7
Attach the Dust Port (#14) to the back of the Large Fence (#4) using four
¼-20 x 3/8" Phillips Pan Head Machine Screws (#18) so that the port angles
up, making it easy to attach a vacuum hose.
2.
Publicidad
