Publicidad
Precision Router Table Fence Assembly
Step 13
Locate the 48" Center Reading Tape (#35) and trim each side to the
17-15/16" mark with a sturdy scissors. Carefully remove one corner of the
backing, apply the tape 1/16 from the edge of the Large Fence and continue
to remove the backing while you press the tape across the surface of the
fence. Be careful to eliminate all air bubbles under the tape as you move
across. If properly applied, the other end of the tape should also come to rest
1/16" from the other edge of the Large Fence.
For most applications, the tape will be used as a distance reference instead of
an exact measurement. To precisely center the tape on the router bit, loosen
the T-Knobs on the Fence Mount and make adjustments as necessary.
Step 14
Mount the Fence Guard (#11) by sliding two ¼-20 x 1-1/4" T-Bolts (#25) into
the T-slot on the top, front edge of the Large Fence. Slide both to the center
of the fence, add two Plastic Spacer Washers (#24) onto each T-Bolt, and
place the Fence Guard (#11) on to each T-Bolt. Fasten using two ¼" Brass
Washers (#17) and two Small T-Knobs (#16).
Step 15
Slide the fence to the back of the router table top. Locate the 8 ¼"
Tape Slider (#8). Insert the Tape Slider into the Mounting Rail (#1)
and thread the Knurled Thumb Screw (#19) from the bottom side
of the Mounting Rail to hold the Tape Slider in place. Locate the 8"
Measuring Tape (#9). Position the tape so the 2" marking is on the
front edge of the Tape Slider. Apply by peeling the adhesive backing
from the Measuring Tape and pressing into place. The Measuring
tape and Tape Slider are the same length so no cutting of the tape
is necessary. When the tape requires adjustment, simply loosen the
Thumb Screw, make your adjustment as necessary, and re-tighten.
Step 16
Slide the Precision Lens Cursor (#10) into the Mounting Rail as far as
is shown, and lock it into place using the 10-32 x ¼" Nylon Screw (#20)
This Screw can be loosened and re-tightened to make any adjustments
necessary to the Precision Lens Cursor.
6.
6.
Publicidad
