Publicidad
5.
Precision Router Table Fence Assembly
Step 8
Flip the Large Fence over. On the underside of the Fence you will fi nd two
slots running down the length of the extrusion. Insert the eight Trak Bumpers
(#34), approximately 4.5" and 12" from each end, as shown in the image.
Correctly installed Trak Bumpers will reduce friction and ensure the fence
glides smoothly across the table top.
Step 9
Insert six ¼-20 x 1" Phillips Flat Head Machine Screws (#22) through the
pre-drilled/countersunk holes in the two separate Fence Faces and barely
thread the six corresponding ¼" Jam Nuts (#27) onto the Screws. Be sure
to use the thinner Jam Nuts and not the thicker Hex Nuts. The Hex Nuts
are too large to slide into the t-slot of the Fence. With the bolts and nuts
secured onto the Fence Faces, take each Face and slide it onto the front
t-slot of the Fence, center, and tighten each bolt down securely
Step 10
Slide the two ¼-20 x 2-1/4" Hex Bolts (#26) into the T-slot on the back of
the Large Fence (#4) next to the Fence Mount (#3). Adjust the position of
the two bolts so that they fi t into the two slots on top of the Fence Mount
and move the fence so its centered on the router bit opening. Lock the
fence into place using two ¼" Brass Washers (#17). and two T-Knobs
(#16).
Step 11
With the fence centered on the bit opening, use a rule to bring the fence
perfectly parallel to the miter slot. Tighten the four ¼-20 3/8" Phillips Pan
Head Machine Screws (#18) that you installed earlier in Step 5, to lock the
fence into position.
Step 12
On the other end of the fence, slide the head of a ¼-20 x ¾" Hex Bolt (#31)
into the T-Slot. Slide the slotted end of the Right Angle Bracket (#12) around
the Hex Bolt and fasten with one ¼" Fender Washer (#33) and one ¼" Hex
Nut. Before tightening the nut, align the Right Angle Bracket over the 6" slot
on the left side of the Kreg Router Table Top. Place the Brass T-Nut (#30)
through the slot from the underside of the Router Table Top and attach the
Extension Knob Asembly (#13) by putting it through the Right Angle Bracket
and threading it into the Brass T-Nut. Once the right angle bracket is correctly
positioned, tighten the hex nut to secure it into place.
Publicidad
