Motorola PMPN4523 Guia Del Usuario página 10

MN006348A01-AB
Chapter 1: IMPRES Batteries and Chargers
Status
Standby
End of Service Life
Recalibration
1.3
IMPRES Battery Initialization
For a full IMPRES functionality, a new IMPRES battery must be initialized by the charger.
The charger automatically detects the new IMPRES battery, and automatically starts initialization.
Initialization is the first calibration and reconditioning of an IMPRES battery.
Phases of Battery Initialization
The first phase is a battery discharge, indicated by a steady amber LED. The second phase is a full
charge, indicated by a steady green LED. Refer to
NOTICE: This process may take up to 12 hours or more to complete, depending on the state of
charge and capacity of the battery. Interruption of either phase delays initialization until the next
charging opportunity.
1.4
IMPRES Pocket-to-Pocket
When charging IMPRES batteries, the IMPRES charger records charging information in the battery
memory.
Charging can resume if the user remove IMPRES battery from one IMPRES charger pocket and within
30 minutes, insert it into the same or a different IMPRES charger pocket.
1.5
Automatic IMPRES Calibration and Recondition
The IMPRES charger automatically assesses the condition of an IMPRES battery.
Based on the condition, the charger automatically calibrates and reconditions the battery. Interruption
of either the discharge phase or the full charge phase delays calibration until the next charging
opportunity.
NOTICE: The IMPRES battery must be outside from the IMPRES charger pocket for more than
30 minutes for an automatic calibration and recondition.
10
LED Status
Flashing amber
Alternating red and
green
Alternating amber and
green
IMPRES Battery Charging Indicators on page
Comments
• Battery is waiting
to rapid charge.
• Battery may be too
hot, too cold, or
low voltage.
• Charger may be
too hot.
Battery remains usa-
ble but may be near-
ing the end of its rated
service life.
Calibrate the battery.
9.