Motorola Solutions Authorized Batteries - Motorola PMPN4523 Guia Del Usuario

Tabla de contenido

Idiomas disponibles

1.5.1

IMPRES 2 End of Service Life LED Indication

As batteries are used, normal wear reduces available capacity. At the successful completion of

calibration and reconditioning, IMPRES 2 chargers compare IMPRES 2 battery capacity to the battery

Rated Capacity.

When the capacity is at a very low value, the IMPRES 2 battery may be nearing its End of Service.

1.5.2

Initiating Calibration and Recondition Manually

Prerequisites:Ensure that the IMPRES battery is removed from the charger for more than two and a

half minutes.

Procedure:

1 Insert the battery into the charger pocket.

2 Remove the battery from the charger pocket.

3 Reinsert the battery into the charger pocket within 5 seconds.

Calibration and recondition start immediately, beginning with battery discharge indicated by a

steady amber LED status. Calibration and recondition are complete only after a full charge

indicated by a steady green LED status. See

1.5.3

Terminating Calibration and Recondition Manually

Procedure:

1 Remove the battery from the charger pocket.

2 Reinsert the battery into the charger pocket within 5 seconds.

Battery discharge immediately terminates and normal battery charging starts. The LED indicates

charge status.

1.6

Authorized Power Supplies and Batteries

This section list out authorized accessories to be used with your charger.

1.6.1