Connect The Charger To The Power - Ingeteam NEO Pro Manual De Instalacion Y Uso

Installation
CAUTION
In the case of the STAND, use the screws that come with it in the packaging.

3.1.8. Connect the charger to the power

Connect the electrical terminals of the power cable to the corresponding points on the charger.
CAUTION
Make sure that all screws are suitably tightened for effective contact of the active elements of the conductor.
Neutral
Phase 1
Ground
• OPTIONAL: If a CURVE device is also going to be installed, connect the wiring from that device. For more
information, see "Installation of the CURVE
• OPTIONAL: If the charger will be connected to a three-phase energy meter, to communications equipment
(modem, router, switch, etc.) or to another charger, connect the Ethernet wiring from that device. For
more information, see
charger or a communications
ABV2012IQM01_ - Installation and Operation Manual
NEO Pro (single-phase)
device".
"Installation of the CURVEx3"
element".
Wall mounting: 4.8x38 screw
STAND assembly: M5x12 screw
NEO Pro (three-phase)
Neutral
Phase 1
Phase 2
Phase 3
Ground
and/or "Connection of the charger to another
Ingeteam
EN
ES
FR
IT
13