Password Protection; Quick Application Selection; Selecting The Menu Detail - Parker 650 Serie Manual De Producto

Note:

Password Protection

ACTIVATE
Steps
Actions
Go to
1
Press
Enter new
password using
2
Press
repeatedly until
3
top of menu is
reached
Press to
4
activate
password
Default = 0000, de-activated
Any other value is a password

Quick Application Selection

Selecting the Menu Detail

650 Series AC Drive
Local to Remote Control:
View the Local Setpoint
Hold this key down until
is removed from the display
Release the key to display
For safety reasons, the drive will not return to Remote Control if this will cause the drive
to start. Check RUN and JOG inputs are low.
When activated, an odd-numbered password prevents unauthorised parameter modification by
making all parameters read-only. The local setpoint is not made read-only if an even-numbered
password is used. Password protection is set-up using the
Display Actions
Try to edit any
parameter with
password activated
Enter current
password using
for example
, Remote
Setpoint or
Press
Local Setpoint
, Remote
A drive will power-up with the last
password status. Temporary de-
Setpoint or
activation is lost on power-down.
Local Setpoint
You can navigate immediately to the
APPLICATION parameter,
shown opposite.
Then, press the key to display the current
Application. Press again to allow the parameter to be changed.
Use the keys to select the appropriate Application by number.
Press the key to load the Application.
Refer to Chapter 12: "Applications" for further information.
For ease of operation the drive can display full or reduced menus. Refer to Chapter 6 to see how
the setting changes the displayed menu. Additional parameters are indicated with
Navigate to the parameter (SET::SETP::ST99) and press the
or partial menu detail. The default setting of 0 provides partial menu detail. Set the parameter to
1 for full menu detail.
TEMPORARY DE-ACTIVATION
Display
for example
Original
parameter
displayed,
password
de-activated
P
1, from power-up, as
The Keypad
LOCAL
REMOTE
parameter
REMOVE PASSWORD
Actions
Go to

Press
Enter current
password using
Press
Reset to 0000
using
Press to
remove
password
Hold down the key opposite:
Power-up the drive, continue
to hold for at least 1 second
key. This toggles full
5-5
Display

for example
HOLD
F
in the table.