Greenlee 855GX IntelliBENDER Manual De Instrucciones página 18

Operation (cont'd)
BendWorks™ Software Troubleshooting (cont'd)
Preprocess Errors
36 Bend Angle Too Big
37 Bend Angle Too Small
39 Distance Too Small From
End Of Last Bend To End
Of Pipe
40 Distance Too Small From
Start Of
Pipe To Start Of First Bend
41 Loop Run
42 Multiple Benders
Not Supported
43 Type Not Supported
44 Back to Back Bends
Informational Messages
55 No Valid Split From
Either Direction
Greenlee Tools, Inc.
ErrorCode.BendAngleToolSmall, 34359738368
ErrorCode.BendRadiusTooSmall, 68719476736
ErrorCode.DistanceTooSmallFromEndOfLastBendToEndOfPipe,
274877906944
ErrorCode.DistanceTooSmallFromStartOfPipeToStartOfFirstBend,
549755813888
ErrorCode.LoopRun, 1099511627776
ErrorCode.MultipleBendersNotSupported, 2199023255552
ErrorCode.TypeNotSupported, 4398046511104
ErrorCode.BacktoBackBends, 8796093022208
ErrorCode.NoValidSplitFromEitherDirection, 18014398509482000
855GX Electric Bender
18
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Explanation of Error
Bend angle cannot be bigger than
90 degrees.
Bend angle cannot be smaller than
5 degrees.
The distance from the end of
the last bend to the end of the
run cannot be shorter than the
Coupling Depth.
The distance from the start of
the run to the start of the first
bend cannot be shorter than the
Coupling Depth.
The conduit run is in a loop.
Multiple benders not supported.
The conduit type is not supported.
Conduit Run cannot have back to
back bends. Distance between two
bends cannot be 0
Explanation of Error
No valid split from either direction.