Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Concrete and tank hole alignment
Check your measurements to ensure that the opening on the bottom of the tank aligns with the thermal
earth tube placement in the concrete. The opening on the bottom of the tank is off center. Ensure that the
water supply lines are not touching the sides of the thermal earth tube.
Underneath the WaterPro2
Unpacking the box
Recommended parts
In colder climates, we strongly recommend the use of one or more thermal earth tubes to help keep the vertical water supply
•
line from freezing. The thermal earth tube(s) must be long enough to extend 1 foot (305 mm) below the normal frost line.
½ inch NPT male fitting to connect the water supply line to the ½ inch flex line inside the tank. If your water supply line is more
•
than ½ inch in diameter, you will also need an adapter.
250 W immersion heater for heating water in the tank (optional).
•
Recommended tools
Adjustable wrench
•
Pipe wrench
•
Measuring tape
•
Utility knife
•
Level
•
Hammer drill
•
½ inch masonry bit
•
Hammer
•
½ inch ratchet wrench
•
Caulk
•
5
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
