Bronze Luxury-Lift Power Recliner Troubleshooting - LAZBOY Bronze Luxury-Lift Instrucciones De Operación

Bronze Luxury-Lift
Troubleshooting
WARNING
– To reduce the risk of serious injury:
• Do not attempt to disassemble or service the pump or motor; no serviceable parts are
inside. Contact your La-Z-Boy ® dealer for service.
• Check the condition of the power supplies, electrical cords, plugs, and connectors often.
Keep the power supplies and electrical cords away from heat sources. Never operate
the unit with a damaged power supply, electrical cord, plug or connector. Contact your
La-Z-Boy ® dealer for service.
• The Bronze lift chairs are intended for a single occupant, not exceeding 300 pounds.
Do not operate the chair with more than one occupant in or on any part of the chair.
Troubleshooting for Lift and Recline Operation
If the recline or lift features do not work, check the following:
1. Make sure the 120-volt power cord is plugged into an electrical outlet.
2. Check the power supply to make sure the green LED power indicator light is on.
3. Make sure the electrical outlet is working. For example, make sure there are no blown fuses or
tripped circuit breakers. If you are unsure of the outlet's condition, check with a qualified
electrician or service technician.
4. Make sure all the connections are secure; refer to the Assembly Instructions.
5. Make sure the electrical cords are not crimped or pinched. Make sure the electric cord or plug
is not damaged.
6. Make sure the operating capacity has not been exceeded and there is only one occupant in the
chair; refer to the Operating Instructions.
Power Supply Replacement
If the power supply must be replaced:
1. Unplug the power supply from the electrical outlet.
2. Disconnect the 120-volt power cord from the power supply, and disconnect the power supply
from the motor connector at the rear lower base of the unit. Refer to the Assembly Instructions.
3. Connect the new power supply to the motor connector at the rear lower base of the unit; align
the motor connector to the power supply and push together until fully seated. Connect the
120-volt power cord to the new power supply; align the connector to the power supply and
push together until fully seated. Refer to the Assembly Instructions.
4. Proceed to the Battery Backup Assembly Instructions.
16
® Power Recliner
( age intentionally left blank )
17