Woods BRUSHBULL BB600XE Manual Del Usuario página 18

CROSSBAR INSTALLATION
Using emery cloth (220 or finer), remove surface rust, Loctite
eign material from hub, splined gearbox, vertical shaft, and crossbar as
shown in Figure 20.
Figure 20
.
Refer to Figure 21
8.
Install crossbar (2) on splined shaft. Install washer (5) and nut (3). Torque
nut to 610.1 N-m (450 lbs-ft).
9.
Install cotter pin (4) (supplied) through gearbox shaft and slots in nuts.
Twist end of pin around nut (3).
Figure 21
18 Dealer Service
UNIVERSAL JOINT REPAIR
®
1. Yoke
and for-
2. Bearing cup
3. Retaining ring
4. Bearing cross
U-Joint Disassembly
1.
Remove external snap rings from yokes in four locations as shown in
Figure 23.
2.
With snap rings removed, support drive in vise, hold yoke in hand and tap
on yoke to drive cup up out of yoke. See Figure 24.
3.
Clamp cup in vise as shown in Figure 25 and tap on yoke to completely
remove cup from yoke. Repeat Step 2 & 3 for opposite cup.
Figure 22
. U-Joint Exploded View
Figure 23.
Remove Snap Ring
Figure 24.
Remove Bearing Cups
MAN1255 (3/19/2018)